So I installed PHP70

sudo yum install -y \
    php70-php-php \
    php70-php-common \
    php70-php-cli \
    php70-php-devel \
    php70-php-fpm \
    php70-php-mysqlnd \
    php70-php-xml \
    php70-php-gd \
    php70-php-mcrypt \
    php70-php-soap \
    php70-php-mbstring \
    php70-php-pear \
    php70-php-pdo \
    php70-php-pecl-redis \
    php70-php-pecl-yaml \
    php70-php-pecl-pdflib

I then ran php -v and the executable was not found. I realized it installed into  /etc/opt/remi/php70/ which is fine, I realized it all installs as "php70-*" - I had a similar challenge trying to start php-fpm

systemctl start php-fpm.service // fails
systemctl start php70-php-fpm.service // works

Is there an installation flag that just makes this install as "php" in the normal fashion (that is, without "php70-*" preceding all the components)?